Life-fitness X Series Manuel d'utilisateur

rev 12 Aug 2008X3/X3i Cross-trainer

61.4 SETUPTools required: Socket set, Phillips Screwdriver, 9/16 open end wrenchPlease read instructions carefully before assembly. Be sure to assem

76. Insert two (#4) 1 bolts and two (#9) washers into thebackside of the connector joint on the base frame (B). Starteach bolt, and then tighten with

8STEP 5Plug cables into the back of display console:1. Plug the 10-pin connector at the end of the upper wire harness into the 10-pin connector (10P)

91.4 SETUP CONTINUEDSTEP 6Attach the display console to the console plate:1. Line up the four holes in the back of the console plate (H) with the four

111.5 HOW TO STABILIZE THE LIFE FITNESS CROSS-TRAINERAfter placing your Cross-Trainer where it will be used,check its stability. If there is even a s

X3-XX0X-0102 CROSSTRAINERBOM (BILL OF MATERIALS)Item Seq Item Description Quantity Item Seq Item Description Quantity1 7260202 WLDMT, X3 BASE FRAME BL

1277162120374052415943151160443943541042359515757513617181819433412WASHERS (ITEM 57) ARE TO BE PLACEDON THE INSIDE OF THE FLYWHEEL BRACKETAND NOT ON T

1413

4747484848474848313230 484X 484X23233333 502X2X 508466038533853846

222245455858575766555556566161334549545449455857555554545758454949

**Bill for this drawing**Item Description ItemSeq.Quantity7261302 WLDMT, UPRIGHT FRAME, X3 BLK 1 16909501 ASSY, ROCKER-LH 2 16909401 ASSY, ROCKER-RH 3

51.2 PARTSLIST0. Accessory Bracket Fastener Qty: 2 1. Phillips Pan Head Screw  Clevis Cover Fastener Qty: 41/4"-20 x 3/4" LONG 3234101 10-3